- #Hp t5135 install windows xp install#
- #Hp t5135 install windows xp serial#
- #Hp t5135 install windows xp drivers#
Now, the SATA AHCI driver should be successfully installed, and the notebook should boot into Windows with the SATA Device Mode set to AHCI. Go back to your device configurations sub menu and change the SATA Device Mode back to AHCI, save settings there (F10) and upon exit, save changes and reboot. During restart, press the F10 key and enter the BIOS setup utility. You can find the updated controller in the device manager.ġ9. The driver will install, and completing the Hardware update Wizard appears. From this list, select the Intel(R) 5 Series 6 Port SATA AHCI Controller. This will list several SATA AHCI Controllers.
#Hp t5135 install windows xp drivers#
Select location: c:\folder you saved AHCI drivers to.ġ5. Select Don't search I will choose the driver to install. Take the unit out of the box, attach it to the network and it downloads settings automatically.
#Hp t5135 install windows xp install#
Select Install from a list or specific location (Advanced). Run your HP t5135 in the familiar local mode with settings stored locally, or run it in a 'stateless' (network) mode with settings stored remotely. In Welcome to the Hardware Update Wizard, select No, not this time.
#Hp t5135 install windows xp serial#
Right-click on the Intel(R) 5 Series/3400 Series Chipset Family 4 port Serial ATA Storage Controllerħ. You will find the Intel native SATA storage controller driver installed.Ħ. Click the + symbol beside IDE ATA/ATAPI controllers, this would show the devices under this category.ĥ. That will enable your HDD to be able to use native command queuing, which is not available to you in IDE mode. The tricky part is to install the SATA AHCI driver after you installed XP so you can change the setting back to AHCI. Right-click the My Computer icon, click Manage, select Device ManagerĤ. Boot from your XP disk and it should now install problem-free. Then download, extract, and save these drivers to a folder you name whatever you want. First download and install the chipset driver and reboot.
I suspect that You probably mean AHCI (advanced host controller interface).ġ. You cannot change the setting back until you load the ACHI driver, or the notebook won't boot.
Install XP, post back when you are done, and I will give you the step by step directions to install the ACHI driver so you can change the storage setting back from IDE to ACHI. That will enable your HDD to be able to use native command queuing, which is not available to you IDE mode. The tricky part is to install the SATA ACHI driver after you installed XP so you can change the setting back to ACHI. Save the setting there (F10 key), and again when you exit.īoot from your XP disk and it should now install problem-free. Read the setup guide section of the service manual at the link below, Chapter 5, page 100.Ĭhange the SATA device mode from ACHI to IDE. On your particular notebook it is easy to install Windows XP if you know what to do.
0 kommentar(er)
